Difference between revisions of "Hdparm"
From CBLFS
Jump to navigationJump to search (→Introduction to Hdparm) |
|||
| (4 intermediate revisions by 3 users not shown) | |||
| Line 7: | Line 7: | ||
---- | ---- | ||
| − | + | {{Package-Introduction|hdparm - get/set ATA/SATA drive parameters under Linux|http://hdparm.sourceforge.net/}} | |
| − | |||
| − | |||
== Dependencies == | == Dependencies == | ||
| Line 61: | Line 59: | ||
|-valign="top" | |-valign="top" | ||
! Installed Programs: | ! Installed Programs: | ||
| − | | | + | | /sbin/hdparm |
|-valign="top" | |-valign="top" | ||
! Installed Libraries: | ! Installed Libraries: | ||
| Line 77: | Line 75: | ||
| provides a command-line interface to various hard disk ioctls supported by the stock Linux ATA/IDE device driver subsystem. | | provides a command-line interface to various hard disk ioctls supported by the stock Linux ATA/IDE device driver subsystem. | ||
|} | |} | ||
| + | |||
| + | [[Category:General Utilities]] | ||
Latest revision as of 03:18, 6 February 2011
| Download Source: | http://prdownloads.sourceforge.net/hdparm/hdparm-9.37.tar.gz |
|---|
Contents
Introduction to Hdparm
hdparm - get/set ATA/SATA drive parameters under Linux
Project Homepage: http://hdparm.sourceforge.net/
Dependencies
Non-Multilib
Compile the package:
make
Install the package
make install
Multilib
This package does not provide any libraries so only one installation is needed.
32Bit
Compile the package:
make CC="gcc ${BUILD32}"
Install the package
make install
N32
Compile the package:
make CC="gcc ${BUILDN32}"
Install the package
make install
64Bit
Compile the package:
make CC="gcc ${BUILD64}"
Install the package
make install
Contents
| Installed Programs: | /sbin/hdparm |
|---|---|
| Installed Libraries: | ??? |
| Installed Directories: | ??? |
Short Descriptions
| hdparm | provides a command-line interface to various hard disk ioctls supported by the stock Linux ATA/IDE device driver subsystem. |
|---|
