Hdparm: Difference between revisions
From CBLFS
Jump to navigationJump to search
I added the "Contents" section. |
No edit summary |
||
| (7 intermediate revisions by 4 users not shown) | |||
| Line 2: | Line 2: | ||
|-valign="top" | |-valign="top" | ||
!Download Source: | !Download Source: | ||
| http://prdownloads.sourceforge.net/hdparm/hdparm- | | http://prdownloads.sourceforge.net/hdparm/hdparm-{{Hdparm-Version}}.tar.gz | ||
|} | |} | ||
---- | ---- | ||
{{Package-Introduction|hdparm - get/set ATA/SATA drive parameters under Linux|http://hdparm.sourceforge.net/}} | |||
== Dependencies == | == Dependencies == | ||
| Line 33: | Line 26: | ||
=== 32Bit === | === 32Bit === | ||
Compile the package: | |||
make CC="gcc ${BUILD32}" | |||
Install the package | |||
make install | |||
=== N32 === | === N32 === | ||
Compile the package: | |||
make CC="gcc ${BUILDN32}" | |||
Install the package | |||
make install | |||
=== 64Bit === | === 64Bit === | ||
| Line 43: | Line 48: | ||
Compile the package: | Compile the package: | ||
make | make CC="gcc ${BUILD64}" | ||
Install the package | Install the package | ||
| Line 54: | Line 59: | ||
|-valign="top" | |-valign="top" | ||
! Installed Programs: | ! Installed Programs: | ||
| | | /sbin/hdparm | ||
|-valign="top" | |-valign="top" | ||
! Installed Libraries: | ! Installed Libraries: | ||
| Line 70: | Line 75: | ||
| provides a command-line interface to various hard disk ioctls supported by the stock Linux ATA/IDE device driver subsystem. | | provides a command-line interface to various hard disk ioctls supported by the stock Linux ATA/IDE device driver subsystem. | ||
|} | |} | ||
[[Category:General Utilities]] | |||
Latest revision as of 03:18, 6 February 2011
| Download Source: | http://prdownloads.sourceforge.net/hdparm/hdparm-9.37.tar.gz |
|---|
Introduction to Hdparm
hdparm - get/set ATA/SATA drive parameters under Linux
Project Homepage: http://hdparm.sourceforge.net/
Dependencies
Non-Multilib
Compile the package:
make
Install the package
make install
Multilib
This package does not provide any libraries so only one installation is needed.
32Bit
Compile the package:
make CC="gcc ${BUILD32}"
Install the package
make install
N32
Compile the package:
make CC="gcc ${BUILDN32}"
Install the package
make install
64Bit
Compile the package:
make CC="gcc ${BUILD64}"
Install the package
make install
Contents
| Installed Programs: | /sbin/hdparm |
|---|---|
| Installed Libraries: | ??? |
| Installed Directories: | ??? |
Short Descriptions
| hdparm | provides a command-line interface to various hard disk ioctls supported by the stock Linux ATA/IDE device driver subsystem. |
|---|
