Difference between revisions of "KDE4/kdebase-workspace"
From CBLFS
Jump to navigationJump to search (→Configuring) |
(→Configuring) |
||
| Line 84: | Line 84: | ||
If you install [[Linux-PAM]], it will be used. Then you should create pam.d config to enable KDM logins: | If you install [[Linux-PAM]], it will be used. Then you should create pam.d config to enable KDM logins: | ||
| + | |||
cat > /etc/pam.d/kde << "EOF" | cat > /etc/pam.d/kde << "EOF" | ||
#%PAM-1.0 | #%PAM-1.0 | ||
| − | auth | + | auth required pam_nologin.so |
| − | + | aut include system-auth | |
| − | account include | + | account include system-auth |
| − | password include | + | password include system-auth |
| − | session include | + | session include system-auth |
EOF | EOF | ||
Revision as of 17:21, 11 December 2008
| Download Source: | ftp://ftp.kde.org/pub/kde/stable/4.3.5/src/kdebase-workspace-4.3.5.tar.bz2 |
|---|
Contents
Dependencies
Required
- KDE4/KdeSupport (Only qimageblitz)
- KDE4/KdeLibs
Recommended
Non-Multilib
Compile the package:
mkdir -v build &&
cd build &&
cmake -DCMAKE_INSTALL_PREFIX=${KDEDIR} -DSYSCONF_INSTALL_DIR=/etc/kde .. &&
make
Install the package:
make install
Multilib
32Bit
mkdir -v build &&
cd build &&
USE_ARCH=32 PKG_CONFIG_PATH="${PKG_CONFIG_PATH32}" \
cmake -DCMAKE_INSTALL_PREFIX=${KDEDIR} \
-DSYSCONF_INSTALL_DIR=/etc/kde \
-DCMAKE_CXX_FLAGS=${BUILD32} \
-DCMAKE_C_FLAGS=${BUILD32} \
.. &&
make
If kdebase fails "which it has done to me(oppiz) on several builds" let it error out with the ld lib64 type error. Start with clean source, run the cmake command above then switch to the below to make and make install. This is not proper and should not be done. It needs to be fixed and the problem located.
for file in $( find ./ -name build.make ); do sed -i 's:/lib64:/lib:g' $file ; done for file in $( find ./ -name *link.txt ); do sed -i 's:/lib64:/lib:g' $file ; done make for file in $( find ./ -name cmake_install.cmake ); do sed -i 's:/lib64:/lib:g' $file ; done make install
Install the Package
make install
N32
64Bit
mkdir -v build &&
cd build &&
USE_ARCH=64 PKG_CONFIG_PATH="${PKG_CONFIG_PATH64}" \
cmake -DCMAKE_INSTALL_PREFIX=${KDEDIR} \
-DSYSCONF_INSTALL_DIR=/etc/kde \
-DLIB_SUFFIX=64 \
-DCMAKE_CXX_FLAGS=${BUILD64} \
-DCMAKE_C_FLAGS=${BUILD64} \
.. &&
make
Install the Package
make install
Configuring
If you install Linux-PAM, it will be used. Then you should create pam.d config to enable KDM logins:
cat > /etc/pam.d/kde << "EOF" #%PAM-1.0 auth required pam_nologin.so aut include system-auth account include system-auth password include system-auth session include system-auth EOF
