Difference between revisions of "Poppler"
From CBLFS
Jump to navigationJump to searchLine 24: | Line 24: | ||
* [[Gtk-Doc]] | * [[Gtk-Doc]] | ||
* [[libglade]] | * [[libglade]] | ||
+ | |||
+ | == Poppler Data Package == | ||
+ | |||
+ | Before installing Poppler install the data package by extracting it into its own directory then running the following command: | ||
+ | |||
+ | make prefix=/usr install | ||
== Non-Multilib == | == Non-Multilib == |
Revision as of 12:08, 20 July 2008
Download Source: | http://poppler.freedesktop.org/poppler-0.12.4.tar.gz |
---|---|
Download Data Package: | http://poppler.freedesktop.org/poppler-data-0.4.0.tar.gz |
Contents
Introduction to Poppler
The Poppler package contains a PDF rendering library. This is useful for providing PDF rendering functionality as a shared library.
Project Homepage: Unknown
Dependencies
Optional
- Pkg-config
- libjpeg
- FontConfig
- cairo
- Gtk2
- Qt3 (required if you wish to use Poppler with KdeGraphics)
- Qt4
- Gtk-Doc
- libglade
Poppler Data Package
Before installing Poppler install the data package by extracting it into its own directory then running the following command:
make prefix=/usr install
Non-Multilib
Compile the package:
./configure --prefix=/usr --sysconfdir=/etc \ --enable-opi --enable-zlib && make
Install the package
make install && install -v -m644 -D README /usr/share/doc/poppler-0.12.4/README
Multilib
32Bit
Compile the package:
CC="gcc ${BUILD32}" CXX="g++ ${BUILD32}" USE_ARCH=32 \ PKG_CONFIG_PATH="${PKG_CONFIG_PATH32}" \ ./configure --prefix=/usr --sysconfdir=/etc \ --enable-opi --enable-zlib && make
Install the package
make install
N32
Compile the package:
sed -i 's:$QTDIR/lib:&32:g' configure && CC="gcc ${BUILDN32}" CXX="g++ ${BUILDN32}" USE_ARCH=n32 \ PKG_CONFIG_PATH="${PKG_CONFIG_PATHN32}" \ ./configure --prefix=/usr --sysconfdir=/etc \ --libdir=/usr/lib32 \ --enable-opi --enable-zlib && make
Install the package
make install
64Bit
Compile the package:
sed -i 's:$QTDIR/lib:&64:g' configure && CC="gcc ${BUILD64}" CXX="g++ ${BUILD64}" USE_ARCH=64 \ PKG_CONFIG_PATH="${PKG_CONFIG_PATH64}" \ ./configure --prefix=/usr --sysconfdir=/etc \ --libdir=/usr/lib64 \ --enable-opi --enable-zlib && make
Install the package
make install && install -v -m644 -D README /usr/share/doc/poppler-0.12.4/README