Difference between revisions of "XML::Parser"
(I added a note about DESTDIR.) |
Chipster19 (talk | contribs) |
||
| (3 intermediate revisions by 2 users not shown) | |||
| Line 2: | Line 2: | ||
|-valign="top" | |-valign="top" | ||
!Download Source: | !Download Source: | ||
| − | | http://cpan.org/authors/id/ | + | | http://search.cpan.org/CPAN/authors/id/C/CH/CHORNY/XML-Parser-{{Perl Module XML::Parser-Version}}.tar.gz |
|} | |} | ||
---- | ---- | ||
| + | |||
| + | {{Blank-Package-Introduction}} | ||
== Dependencies == | == Dependencies == | ||
| Line 33: | Line 35: | ||
{{Perl Module Common Build}} | {{Perl Module Common Build}} | ||
| + | |||
| + | [[Category:Perl Modules]] | ||
Latest revision as of 02:03, 22 February 2011
| Download Source: | http://search.cpan.org/CPAN/authors/id/C/CH/CHORNY/XML-Parser-2.40.tar.gz |
|---|
Contents
Introduction to XML::Parser
Project Homepage: Unknown
Dependencies
Required
Note to DESTDIR Fans
Somehow, when perl creates the Makefile for this module, it is able to figure out that it's in <DESTDIR>/<PERL_LOCATION> instead of simply <PERL_LOCATION>. For example, if you used DESTDIR to install perl in /usr/pkg/perl/5.8.8, it would realize that perl was in /usr/pkg/perl/5.8.8/usr/bin instead of /usr/bin. This means that if you pass DESTDIR to make install (e.g. DESTDIR=/usr/pkg/perl_module_xml-parser/2.40), then it will install the module in /usr/pkg/perl_module_xml-parser/2.40/usr/pkg/perl/5.8.8.
Now, you probably don't want that to happen. If you want the module installed where you installed perl, then you don't have to do anything. It's already setup that way. Just use make install. On the other hand, if you don't want the module to be installed in the same place, then you need to use the following sed after running perl Makefile.PL:
sed -i 's@<PERL_DESTDIR>@@g' Makefile
Of course you need to replace <PERL_DESTDIR> with wherever you installed perl (in the example above that would be /usr/pkg/perl/5.8.8). You can then pass DESTDIR to make install as you normally would and the module will be installed there.
Editor's Note: It is quite possible (even likely) that the behavior of this module with regards to DESTDIR is standard behavior for perl modules. If you happen to be someone that uses DESTDIR and installs a lot of perl modules and can confirm this, please move this section from this page to the Template:Perl Module Common Build page so that the information will be duplicated for all of the perl modules.
Non-Multilib
Compile the package:
perl Makefile.PL && make && make test
Install the package
make install
Multilib
32Bit
Compile the package:
USE_ARCH=32 perl Makefile.PL && make && make test
Install the package
make install
N32
Compile the package:
USE_ARCH=n32 perl Makefile.PL && make && make test
Install the package
make install
64Bit
Compile the package:
USE_ARCH=64 perl Makefile.PL && make && make test
Install the package
make install
