Difference between revisions of "TORCS"
From CBLFS
Jump to navigationJump to searchWeibullguy (talk | contribs) |
Weibullguy (talk | contribs) m |
||
Line 160: | Line 160: | ||
| /usr/lib/torcs, /usr/share/games/torcs | | /usr/lib/torcs, /usr/share/games/torcs | ||
|} | |} | ||
+ | |||
+ | [[Category:Games]] |
Revision as of 08:35, 12 April 2009
Extract the src and robots packages into the same directory before you issue any commands.
The robots package provides the drivers that you will race against. Below is a list of drivers that each of the packages provides:
- robots-base (Required)
- tita
- lliaw
- damned
- cylos1
- tanhoj
- inferno
- inferno2
- robots-berniw (Optional)
- sparkle
- berniw
- berniw2
- berniw3
- robots-bt (Optional)
- bt
- robots-olethros (Optional)
- olethros
The data packages, not extracted with the source and drivers packages, provides track, car, and other information.
Contents
Introduction to TORCS
Project Homepage: Unknown
Dependencies
Required
Recommended
Non-Multilib
Compile the package:
sed -i "/^LIBS/s/$/ -lalut/" src/modules/graphic/ssggraph/Makefile && ./configure --prefix=/usr --x-libraries=/usr/lib && make
Install the package
make install
Multilib
This package does not provide any external libraries so only one installation is needed
32Bit
Compile the package:
sed -i "/^LIBS/s/$/ -lalut/" src/modules/graphic/ssggraph/Makefile && CC="gcc ${BUILD32}" CXX="g++ ${BUILD32}" USE_ARCH=32 \ PKG_CONFIG_PATH="${PKG_CONFIG_PATH32}" \ ./configure --prefix=/usr && make
Install the package
make install
N32
Compile the package:
sed -i "/^LIBS/s/$/ -lalut/" src/modules/graphic/ssggraph/Makefile && CC="gcc ${BUILDN32}" CXX="g++ ${BUILDN32}" USE_ARCH=n32 \ PKG_CONFIG_PATH="${PKG_CONFIG_PATHN32}" \ ./configure --prefix=/usr --libdir=/usr/lib32 && make
Install the package
make install
64Bit
Compile the package:
sed -i "/^LIBS/s/$/ -lalut/" src/modules/graphic/ssggraph/Makefile && CC="gcc ${BUILD64}" CXX="g++ ${BUILD64}" USE_ARCH=64 \ PKG_CONFIG_PATH="${PKG_CONFIG_PATH64}" \ ./configure --prefix=/usr --libdir=/usr/lib64 && make
Install the package
make install
Installing the Data Packages
Each of the data packages you downloaded needs to be extracted in /usr/share/games/torcs. Below is a quick way to do it:
for dpkg in ../TORCS-1.3.0-data*; do tar xvf $dpkg -C /usr/share/games/torcs done
Contents
Installed Programs: | torcs |
---|---|
Installed Libraries: | None |
Installed Directories: | /usr/lib/torcs, /usr/share/games/torcs |