ALSA Tools
Download Source: | ftp://ftp.alsa-project.org/pub/tools/alsa-tools-1.0.23.tar.bz2 |
---|---|
Required Patch: | http://svn.cross-lfs.org/svn/repos/patches/alsa-tools/alsa-tools-1.0.23-ac3dec_config_update-1.patch |
The ALSA Tools package is only needed by those with advanced requirements for their sound card. The tools are not all built together, instead you need to cd into the directory of each tool you wish to compile and run the appropriate commands:
Contents
Introduction to ALSA Tools
The ALSA Tools package contains advanced tools for certain sound cards.
Dependencies
Required
Optional
- Gtk1 (To Build echomixer, envy24control, and rmedigicontrol)
- FLTK (To Build hdspconf and hdspmixer)
- Qt3 (To Build qlo10k1)
ld10k1 must be built before qt10k1
Non-Multilib
Apply the following patch in the top-level directory of alsa-tools before building ac3dec:
patch -Np1 -i ../alsa-tools-1.0.23-ac3dec_config_update-1.patch
Compile each package with:
./configure --prefix=/usr && make
Install each package with:
make install
Multilib
32Bit
Apply the following patch in the top-level directory of alsa-tools before building ac3dec:
patch -Np1 -i ../alsa-tools-1.0.231-ac3dec_config_update-1.patch
Compile each package with:
CC="gcc ${BUILD32}" CXX="g++ ${BUILD32}" USE_ARCH=32 PKG_CONFIG_PATH="${PKG_CONFIG_PATH32}" \ ./configure --prefix=/usr && make
Install each package with:
make install
N32
Apply the following patch in the top-level directory of alsa-tools before building ac3dec:
patch -Np1 -i ../alsa-tools-1.0.23-ac3dec_config_update-1.patch
Before building qlo10k1 apply the following sed so it looks in the correct dir for libraries:
sed -i "s@QTDIR/lib@&32@g" configure
Compile each package with:
CC="gcc ${BUILDN32}" CXX="g++ ${BUILDN32}" USE_ARCH=n32 PKG_CONFIG_PATH="${PKG_CONFIG_PATHN32}" \ ./configure --prefix=/usr --libdir=/usr/lib32 && make
Install each package with:
make install
64Bit
Apply the following patch in the top-level directory of alsa-tools before building ac3dec:
patch -Np1 -i ../alsa-tools-1.0.23-ac3dec_config_update-1.patch
Before building qlo10k1 apply the following sed so it looks in the correct dir for libraries:
sed -i "s@QTDIR/lib@&64@g" configure
Compile each package with:
CC="gcc ${BUILD64}" CXX="g++ ${BUILD64}" USE_ARCH=64 PKG_CONFIG_PATH="${PKG_CONFIG_PATH64}" \ ./configure --prefix=/usr --libdir=/usr/lib64 && make
Install each package with:
make install