Poppler

From CBLFS
Jump to: navigation, search
Download Source: http://poppler.freedesktop.org/poppler-0.12.4.tar.gz
Download Data Package: http://poppler.freedesktop.org/poppler-data-0.4.0.tar.gz

Contents

Introduction to Poppler

The Poppler package contains a PDF rendering library. This is useful for providing PDF rendering functionality as a shared library.

Project Homepage: http://poppler.freedesktop.org/

Dependencies

Recommended

Optional

Poppler Data Package

Before installing Poppler install the data package by extracting it into its own directory then running the following command:

make prefix=/usr install
Caution.png

Note

If the Enlightenment epdf module is going to be built, be sure to pass --enable-xpdf-headers to install unsupported xpdf headers.

Non-Multilib

Compile the package:

sed -i '/MOCQT4=/s@`which moc`@"${QT4DIR}/bin/moc"@' configure
./configure --prefix=/usr --sysconfdir=/etc \
    --enable-zlib &&
make

Install the package

make install &&
install -v -m644 -D README /usr/share/doc/poppler-0.12.4/README

Multilib

32Bit

Compile the package:

sed -i '/MOCQT4=/s@`which moc`@"${QT4DIR}/bin/moc"@' configure
CC="gcc ${BUILD32}" CXX="g++ ${BUILD32}" USE_ARCH=32 \
PKG_CONFIG_PATH="${PKG_CONFIG_PATH32}" \
./configure --prefix=/usr --sysconfdir=/etc \
    --enable-zlib --build=${CLFS_TARGET32} &&
make

Install the package

make install

N32

Compile the package:

sed -i '/MOCQT4=/s@`which moc`@"${QT4DIR}/bin/moc"@' configure
sed -i 's:$QTDIR/lib:&32:g' configure &&
CC="gcc ${BUILDN32}" CXX="g++ ${BUILDN32}" USE_ARCH=n32 \
PKG_CONFIG_PATH="${PKG_CONFIG_PATHN32}" \
./configure --prefix=/usr --sysconfdir=/etc \
    --libdir=/usr/lib32 \
    --enable-zlib &&
make

Install the package

make install

64Bit

If you are building on an architecture other than x86_64, issue the following command to correct the search for Qt3 libraries:

sed -i 's:$QTDIR/lib:&64:g' configure &&

Compile the package:

sed -i '/MOCQT4=/s@`which moc`@"${QT4DIR}/bin/moc"@' configure
CC="gcc ${BUILD64}" CXX="g++ ${BUILD64}" USE_ARCH=64 \
PKG_CONFIG_PATH="${PKG_CONFIG_PATH64}" \
./configure --prefix=/usr --sysconfdir=/etc \
    --libdir=/usr/lib64 \
    --enable-zlib &&
make

Install the package

make install &&
install -v -m644 -D README /usr/share/doc/poppler-0.12.4/README
Personal tools