Distcc

Download Source:	http://distcc.samba.org/ftp/distcc/distcc-2.18.3.tar.bz2

---

Introduction to Distcc

Distcc is a program to distribute builds of C, C++, Objective C or Objective C++ code across several machines on a network. Distcc should always generate the same results as a local build, is simple to install and use, and is usually much faster than a local compile.

Project Home Page: http://distcc.samba.org/

Dependencies

Recommended

• Popt

Optional

• Python (To run tests)
• Gtk2
• libgnomeui

Configuration Information

Add one of the following to configure if you would like to build distccmon-gnome:

--with-gnome
--with-gtk

Not that --with-gnome takes precedence over --with-gtk.

Non-Multilib

Compile the package:

./configure --prefix=/usr --sysconfdir=/etc \
    --with-docdir=/usr/share/distcc-2.18.3 \
    --enable-rfc2553 &&
make

Install the package:

make install

Multilib

This package does not install any libraries so only one installation is needed.

32Bit

Compile the package:

CC="gcc ${BUILD32}" PKG_CONFIG_PATH="${PKG_CONFIG_PATH32}" \
./configure --prefix=/usr --sysconfdir=/etc \
    --with-docdir=/usr/share/distcc-2.18.3 \
    --enable-rfc2553 &&
make

Install the package:

make install

N32

Compile the package:

CC="gcc ${BUILDN32}" PKG_CONFIG_PATH="${PKG_CONFIG_PATHN32}" \
./configure --prefix=/usr --sysconfdir=/etc \
    --with-docdir=/usr/share/distcc-2.18.3 \
    --enable-rfc2553 &&
make

Install the package:

make install

64Bit

Compile the package:

CC="gcc ${BUILD64}" PKG_CONFIG_PATH="${PKG_CONFIG_PATH64}" \
./configure --prefix=/usr --sysconfdir=/etc \
    --with-docdir=/usr/share/distcc-2.18.3 \
    --enable-rfc2553 &&
make

Install the package:

make install

Contents

Installed Programs:	distcc distccd distccmon-gnome distccmon-text
Installed Libraries:	None
Installed Directories:	/usr/share/distcc /usr/share/doc/distcc-2.18.3