Sg3 utils
From CBLFS
Jump to navigationJump to searchDownload Source: | http://sg.danny.cz/sg/p/sg3_utils-1.27.tgz |
---|
Contents
Introduction to Sg3 utils
The sg3_utils package contains utilities that send SCSI commands to devices. As well as devices on transports traditionally associated with SCSI (e.g. Fibre Channel (FCP), Serial Attached SCSI (SAS) and the SCSI Parallel Interface(SPI)) many other devices use SCSI command sets.
Project Homepage: http://sg.danny.cz/sg/index.html
Dependencies
Non-Multilib
Compile the package:
./configure --prefix=/usr && make
Install the package
make install
Multilib
32Bit
Compile the package:
To do ...
Install the package
To do ...
N32
Compile the package:
To do ...
Install the package
To do ...
64Bit
Compile the package:
To do ...
Install the package
To do ...
Contents
Installed Programs: | sg_dd, sg_emc_trespass, sg_format, sg_get_config, sg_ident, sginfo, sg_inq, sg_logs, sg_luns, sg_map26, sg_map, sgm_dd, sg_modes, sg_opcodes, sgp_dd, sg_persist, sg_prevent, sg_raw, sg_rbuf, sg_rdac, sg_read, sg_readcap, sg_read_buffer, sg_read_long, sg_reassign, sg_requests, sg_reset, sg_rmsn, sg_rtpg, sg_safte, sg_sat_identify, sg_sat_set_features, sg_scan, sg_senddiag, sg_ses, sg_start, sg_stpg, sg_sync, sg_test_rwbuf, sg_turs, sg_verify, sg_vpd, sg_write_buffer, sg_write_long, sg_wr_mode |
---|---|
Installed Libraries: | libsgutils.{a,la,so} |
Installed Directories: | /usr/include/scsi |